Shouldn’t be getting drops no
Good suggestion. I’ll try and put my hands on a laptop or similar that has a 2.5G i/f but it may be some time. Right to question the USB C. Thanks.
We’re looking into this, if you could disconnect absolutely everything and if you have a PC (with a 2.5Gbps network card) directly into LAN4 on our router.
This just helps us rule out anything from your side, as we don’t use any traffic managment at all.
We have seen some screwy results via USB-C - We’re all here to help so between us all we’ll get it figured out
Can you speedtest directly from the router? Like I am on a 1.2G service and my PC’s get 940mb/s down/up, but the routers on 2.5WAN gets 1.2Gb/s down, 1g up… LAN side is on 1g
or as @Yayzi_Team says, plumb directly into the matrix
If it helps heres a custom temp AWS iperf3
Will only be up for 1 hour.
3.8.5.206:5201
Thanks Yayzi Staff.
I’m now in correpondance with Stefan from Support.
I’ll shut up for now on the forum. But thanks all for the useful suggestions - we’ll get to the bottom of it.
You are welcome!
Let me know if you need the AWS instance brought back online if you wanted to test against it
Much appreciated @WhyAydan
No problem
@WhyAydan got your own external iperf instance, nice comes in handy
I take that comment bck about saying yayzi are out of depth running a isp,that was a bit harsh,I was tired and frustrated trying to explain my issues with emails,even though I waited a few hours for a reply they were genuinely nice and trying to be helpfull and I wish the yayzi team all the best
They do try their hardest. I’m sure they appreciate the apology. It’s very warm in the UK so I get it
This is worth a look, adds a splash of generative AI. Can use natural language and it’ll create diagrams. Not perfect though as with all the AI.
Hi yah, Can you help with configuration rt-ax86u router pls, I cannot find vlan option.
Thank you
Are you using the Asus firmware or Merlin?
This article suggests that you need 3.0.0.6 and later to support vlans
I have one of these routers in the cupboard. I will dig it out tomorrow and have a look.
Hey, If I were you I would start from installing the newest Merlin firmware for it, then adjusting the settings.